1 x 480mm Low Level Pan, Cistern and Flush Pipe Chrome Spatula Flushing Lever, British Water Reg. Fittings Ring Seat 450 x 340 wall Basin & Brackets Sequential Mono mixer, waste & bottle trap - WRAS approved 5 x Grab Rails 1 x Hinged Arm Support with integral toilet roll holder 1 x 430 x 260 Back Rest Rail & Cushion (supplied with low level pack only) TMV 2 & 3 valves available as extras Cisterns are side entry inlet as standard but can be modified to accommodate alternatives Please Note The Doc M Pack Does Not IncludeSoap Dispenser Tissue Dispenser Hand Dryer About Doc M PackGrab Rails
Doc M Pack Includes
Epoxy polyester powder coated grab rails, mixer tap and flushing lever not recommended for
use in temperatures below 1°Celsius (33.8° Fahrenheit)Bottle Trap
32mm Telescopic Nuflo basin bottle trap (38mm seal), as per Building Regulations 1991
Approved Document H, not to be installed any further than 3 metres from soil stack. Requires
75mm trap seal water depth. Manufactured to BS3943Inlet Valve
Inlet valve is fitted with high pressure valve seat as standard; working pressures from 3 bar to
14 bar static.
- Alternative low pressure valve seat can be found in spares pack and will allow an operating
range of 0.01 bar to 3 bar.Mixer Tap
-Minimum operating pressure is 0.2 bar with a maximum operating pressure of 5 bar.
N.B: Mixer flow rate at 0.2 bar is 3 litres per minute.Thermoset Ring Seat
- Split resistant seat with top fittings manufactured to withstand approx: 158 kgs of weight